How to install your water booster pump. Turns out it's super easy!

The water booster pump has a very vital function in flowing water from the tank to all the faucets in the house.

If the installation is not correct or wrong

It can cause the tap to come out slowly .

As a result, it can interfere with all activities such as washing dishes and doing laundry.

Therefore, it is very important for us to know how to install a good and correct water booster pump.

Come on, let's take a look at the next steps.

How to install a water pump

1. Preparing tools and materials

The first step you should do to install a water booster pump is to prepare the tools and materials.

Here is the list:

1) Water booster pump.

2) Saw.

3) Faucet.

4) Electrical installations .

6) Soldering bar.

7) Glue PVC pipes.

2. How to install a booster pump

Here are some things to pay attention to when installing a booster pump .

1) Leave a distance of approximately 1 meter between the water tank position and the water outlet.

This distance is often applied to the construction of plumbing in a home.

2) Make sure all booster pump connections are turned on. Leave no gaps even for the smallest things.

If you're not careful, your plumbing and booster pump may leak.

3) Make sure the pump is full if you want to check the strength of the water line.

4) You must also ensure that there is sufficient electrical power to support proper operation of the duct system.

5) For installation outside a home or building, you need a protector or cover over the device to keep it dry.

A wet motor can cause a short circuit.

6) If you are not sure how to install the water booster pump, you can refer to the steps directly in the engine manual.

After paying attention to the above, you can proceed to the next step, which is the installation of the pump motor.

Here are the steps:

1) Cut the production pipe from the tower to the tap to be connected to the pumps.

2) Set a faucet stop before and after the pump and place it near the overflow pipe area .

3) The overflow pipe serves as a reserve tank that drains water when the power is out or when regular maintenance is performed.

4) When the pipe is bypassed and all fittings are installed, check the water pressure.

5) Make sure the water pressure is sufficient and flows where it needs to.

6) However, if the water is still flowing slowly, disassemble the bypass tube and ensure the installation is tight.

3. Things to avoid when installing a Turin water pump

In order for the installation process to go smoothly and quickly, it is a good idea to pay attention to the following things that are no less important.

1) Avoid switching the suction water pump and the drive pump because they have their own functions.

2) All types of towers require strong water pressure.

Therefore, avoid installing the pipe valve vertically as it will make the water jammed and difficult to flow.

3) Don't mind the sound of the pressure switch as this is a sign that the engine is losing pressure and if left unchecked can damage the water booster pump.

4) Avoid installing the valve in the tank as it can damage the motor.

Well, this is a good and correct way to install a water booster pump.

If you are still unsure, you can consult an expert or ask a builder for help.

We hope this article was helpful, yes!