How do you repair a gasoline chainsaw?
A chainsaw is an indispensable tool for your garden, but over time, the saw may break down and it is usually difficult to find the problem despite the ease and simplicity of the saw's design.
Technicians, of course, find the malfunction easily, but for the average user, it takes some time to be able to find a solution to the problem. In this guide presented by Jaafar Shop , we will discuss the most prominent malfunctions facing the chainsaw and the methods necessary to solve them.
Chainsaw malfunctions can be divided as follows:
• Malfunctions at the saw engine level
Most chainsaw problems are related to the engine. There are two main problems that affect the engine: the engine does not start at all or runs unstable (the engine may also run for a while and then stop).
The first step to solving engine problems (spark plugs) is to check the ignition system or warped spark plugs. To solve this problem, remove the candle, clean it well, then reinstall it again in its correct place according to the manual (spark plug) that comes with the saw.
Layers of soot often form on the candle as a result of deposits found in the gasoline used. Use high-quality gasoline and oil to ensure that deposits do not form on the engine in the future.
• Malfunctions due to fuel
If the ignition system is fine, you should now check the fuel unit. First, properly prepare and fuel the saw. Most of the problems caused by fuel are due to unbalanced mixing of oil and gasoline. Incorrect fuel mixing, especially adding more oil than gasoline, will cause the chainsaw engine to stall.
Make sure there are no carbon deposits or blockages in the air filter and that the carburetor settings are correct.
If you leave the saw unused for a long time, it is best to remove the old fuel and clean the engine well
Fill the engine with new balanced fuel.
• Chain problems
a. No oil on the tires:
For tires to work properly, oil must flow through them. Check the channels that supply oil to the tires and clean them well. If the problem is not resolved, inspect the oil pump itself by removing part of the chain cover and part of the clutch and unscrewing the bolts to remove the pump cover.
Make sure the pump is working and clean it well. If there are worn parts, replace them. Also make sure that the pipes responsible for the flow of oil to the pump are connected to it properly.
B. Chain break:
The chain often breaks due to a decrease in the quality of the saw as a whole. Buy a high-quality saw from a reliable brand and from a reliable store. You will have to replace the chain if it breaks and lubricate the new chain well before using it.
C. Chain not rotating:
A common mistake often made by beginners is not removing the brake after starting the engine, which causes the chain to prevent rotation.
Dr.. The series does not stop in time:
Sometimes chainsaw users notice that the chain does not stop at the right time. The problem is often the accumulation of sawdust and dust on the brakes. Cleaning the brakes well will most likely solve the problem unless the brake band is damaged, in which case the brake band must be replaced.
• Chainsaw weapon problems
The most common problems with a chainsaw weapon are the weapon being twisted or broken. If the chainsaw arm breaks or becomes bent, you will have to replace it.
• Why must the saw be heated well before using it for the first time?
The new saw should be left for a while to warm it up and to ensure that the saw is working efficiently. The heating period before use is important so that the saw can operate at its maximum capacity without any problems. It's like warming up a car before driving.
It is important that the saw you are going to buy is of high quality and from a reliable place. You can browse the saws on Jaafar Shop and choose the one that best suits your needs.
التعليقات
اترك تعليق او سؤال