Organization of LED lights

Bulbs that generate light using light-emitting diodes (LED) don't always fit into dimmers. It should be stated on the packaging whether the LED is dimmed or not. Dimmable versions can also cause problems, especially with conventional lamp dimmer controllers already installed. This is due, on the one hand, to the electronic components and, on the other hand, to the low power levels of LEDs, which entail special requirements for the lighting device. However, Those who take the following information into consideration when choosing a dimmable solution also achieve the desired lighting results with modern energy-efficient bulbs.

Energy-efficient and cost-effective OSRAM LED reflector lamps provide a good suitable alternative to high-voltage halogen reflector tungsten lamps. Halogen lamps are more energy efficient than incandescent lamps, but in principle they have a very similar structure. If the light switch is pressed, it flows Current through the lamp filament, which is then heated to generate heat and light. Therefore, brightness control is relatively simple: a suitable regulator ensures that less current flows through the wire, resulting in less heating so that the lamp emits less light.

LEDs (light emitting diode) are designed in a completely different way: they are electronic semiconductors. For this reason, LEDs have electronic components, comparable to a small computer, that are switched before the LED to suit the type of control and supply a constant current, among other functions. . These complex electronic features of an LED must be taken into account when specifying a dimmer.

Another complication of some dimmers is the low power levels of the LEDs. The first dimmers were designed for incandescent lamps, which were usually dimmed to the desired brightness using a wall-mounted rotary switch. For example, an LED lamp that is comparable to a 60-watt incandescent lamp requires much less load (only about nine watts) to achieve the same brightness; Therefore, it offers a much smaller margin for light control and therefore requires a dimmer capable of overcoming this complexity. If it fails, the lamp may flicker or make noise, or in the worst case, it may self-destruct or dim.

Therefore, before replacing a tungsten halogen lamp with an LED lamp in a dimmable luminaire, the following information should be considered:

• LEDs should only be used in dimmers whose packaging specifically lists the "dimmable" feature.
• The dimmer used must be suitable for the LED lamp. Information about dimmers compatible with the lamps can be found on the websites of lamp manufacturers.
• Regulatory manufacturer websites also offer compliance lists or helpful online tools. If you are not sure which dampers are already installed, consult the building owner or an electrician.
• Avoid the cheap lighting control systems and LED bulbs that often appear in online bargains. The quality of this type of service provider, apparently "low cost", is usually inadequate and leads to poor performance and failure.
• Only lamps of the same type should be used in a dimmer circuit unless otherwise specified by the dimmer manufacturer. Problems may occur due to different LED designs of lamp manufacturers.
• A dimmer should be used if the brightness decreases from time to time and also, if less light is needed continuously, the ideal choice is a low wattage lamp. The reason is that continuous dimming of a high wattage lamp consumes more energy than using a low wattage lamp.

If you want to read articles similar to the article Learn about the LED lighting system

Follow us on the Jaafar Shop blog

The best store for selling hand tools and tools in Jordan and Egypt

Shop with confidence from the largest hand tools store in Jordan. At Jaafar Shop, you will find electrical tools, hand tools, measuring tools, nail drills, paint screws, and painting supplies. Hand tools supplies and garden supplies. At Jaafar Shop, we provide you with everything you need, including screwdrivers, keys, pliers, and sets. the number. Browse our largest selection of maintenance tools and supplies:

• Hand tools set