Steps to follow to change the hot water tank easily
Enjoying a good hot bath is one of the best relaxing moments after a hard day of work. This moment becomes one of the difficult moments when the hot water tank in the shower only comes out with lukewarm water or is no longer hot. The installation may be problematic or faulty. In the latter case, it is important to change it to take advantage of the benefits of hot water it provides. You should know that replacing or changing the hot water tank is not as difficult as you think. Below we will show you some steps to follow to easily change the hot water tank.
Step 1:
Deflate the balloon before changing it
If you choose to change the hot water tank yourself, it is necessary to pay attention to the brand of the tank you want to put in. It must be of the same brand and the same size (knowing that there are a variety of hot water tanks, which are 100 liters, 150 liters, 300 liters and others). Lots of leakage. Also, the dimensions should be the same to allow you to use the installation of the first without bothering you too much.
Before starting, you should turn off the water supply and turn on the safety tap to prevent water from passing through. You are then asked to deflate the balloon through the evacuation circuit or collect the water in a bucket. After draining the water, you can now begin removing the pipes in order to allow the water to flow in and out.
The tools you will need to complete this step include a tester, screwdriver, screwdriver, and adjustable wrench.
You should take as much care as possible during disassembly to make it easier to reassemble the new balloon. Next, you must electrically disconnect the balloon after testing it with a tester for the presence of current at the resistance level. If there is, the circuit breaker should be turned off.
In this level, all you have to do is remove the ball from the wall. The hot water tank, although empty, is heavy. Therefore, it is necessary that you get help to facilitate the descent.
Step 2:
Install the new balloon
This step will be very easy for you if you have taken the same brand of balloon and the same size first. In fact, you will no longer need to modify the installation to enhance adaptation and operation. So, you just have to reassemble it as you disassembled it and you're done!
You will only have to replace the new safety assembly, olive fittings, flexible, 20/27 fittings, PVC fittings to adjust the evacuation. The first tools that must be installed are the integrity of the pipes, without forgetting to put the seal between the 20/27 fittings before installing them in the second position. Then it is up to you to install the other fittings and make the electrical connection.
But when it comes to the brand you dismantled, it is important to check the resistance of the wall (brick wall, concrete wall, stone wall, etc.)
You will need a hammer used to drill holes in the wall, a simple hammer, a joint bracket, screws, etc. These different tools will be useful for assembling and adapting the new model. To make your job easier, you should remove the protective cover and install the safety unit on the cold water inlet (whose connection is in the double blue tank) and the fitting on the hot inlet (whose red connection is below the ball).
If you want to read articles similar to the article on the steps that must be followed to change the hot water tank easily
Follow us on the Jaafar Shop blog
The best store for selling hand tools and tools in Jordan and Egypt
Shop with confidence from the largest hand tools store in Jordan. At Jaafar Shop, you will find electrical tools, hand tools, measuring tools, nail drills, paint screws, and painting supplies. Hand tools supplies and garden supplies. At Jaafar Shop, we provide you with everything you need, including screwdrivers, keys, pliers, and sets. the number. Browse our largest selection of maintenance tools and supplies:
اترك تعليق او سؤال